Pages: 1 [2]   Go Down
Author Topic: Win7 Multitouch Gestures Plug-In UserInputGesture available  (Read 13184 times)
March 02, 2011, 11:13:16 am
Unfortunately the Channel also does nothing with my Medion Akoya X54000 Multi-Touchscreen  Cry

(The screen works perfectly on Win7.)

Edit: Tested with 4.3 until now, but it works fine with 4.3.2!
April 17, 2011, 10:59:04 am
Successfully tested with Acer T230H.

My suggestions if you encounter problems:

  • Verify that standard Win7 API is supported on your system, e.g. by testing the Microsoft Touch Pack for Windows 7 demos.
  • Slow down, lift fingers. You may be spoiled by smartphones with low screen resolution.
  • Check the number returned in the line "Gesture = ", refer to UserInputGesture_Notes.pdf for explanation.
  • Use the latest Quest3D Version 4.3.2 to test Gesture2Dtest.cgr. It does not work on earlier releases!
  • Open the debug window before loading the cgr an note the feedback there.  Again, monitor the result of the call to UserInputGesture.
  • Publish as exe and as Installer. Check results.

September 21, 2011, 09:54:51 am
UserInputGesture.dll and Win7GestureDemo.exe updated above. Removed July 2011 restriction.
August 27, 2012, 04:45:13 pm
I provide an exe to demonstrate the kiosk capability mentioned before. Just connect a win7 enabled touchsreen and run this exe. Use single clicks to navigate. Trial limitations apply.

* Kiosk-singleClick-Trial.exe (2218.04 KB - downloaded 200 times.)
October 17, 2012, 05:03:59 pm
Channel now available for Quest3D V 5.0 too. x64.
July 11, 2013, 05:55:47 pm
Updated trial material is made available [here].
Pages: 1 [2]   Go Down
Jump to: